It’s something that I often wondered. Acetone, even diluted as nail polish remover, does a great job of cleaning prints and, unlike IPA, doesn’t leave the piece with an awful smell.
Is it mainly price, or are there other reasons?
You must log in or register to comment.
20 daysIt’s really easy to fuck up and have it melt more than you intended. And with resin prints, specifically, there’s not really much needing to be cleaned up like with FDM printing. I prefer to just sand them if there happens to be any burs or whatever.
Really? I’ve been using it and never had any problem with the resin prints “melting”, getting too brittle/soft or break down in any form from over exposure to it
And with resin prints, specifically, there’s not really much needing to be cleaned up like with FDM printing.
Uh, I think you got it backwards, you have to clean the excess resin of a SLA print, while FDM is ready once it’s fully cooled, sanding optional
- CHOPSTEEQ@lemmy.mlEnglish20 days
People who are actually in the know don’t use IPA. Several gallons of denatured alcohol can be had for a fraction of the price of IPA. It’s simply the less efficient but more commonly known chemical for the job.
- cmnybo@discuss.tchncs.deEnglish20 days
The denatured alcohol you typically find in the the US contains a lot of methanol. It’s much more toxic than IPA.
- ExcessShiv@lemmy.dbzer0.comEnglish20 days
Methanol is only a bigger issue if you drink it…unless you were drinking your isopropyl alcohol that’s not a very big concern.
Methylated spirits aren’t typically much cheaper than IPA in a lot of the world until you’re buying industrial quantities, aren’t as effective at dissolving lots of things (which may or may not be relevant depending on the particular resin you’re using), and typically contain additives that leave stains when dried. For hobbyists, this doesn’t seem like a sensible cost saving trick even if it does work for the resin they have.
