3D printing with my first spool of Elegoo Rapid PETG ( https://au.elegoo.com/products/rapid-petg-filament-1-75mm-colored-1kg ) bought at Jaycar , looking very clean and sharp on a slow speed profile
I should recalibrate my Overture PETG ( https://overture3d.com/products/overture-petg ) now that I’ve figured out the speed issues on my printer
It was under 50% relative humidity in my garage today, so I just put the spool right on the printer and hit “go” :)
Over 50% and I usually run active filament from a dry box to the printer
I haven’t gone to the trouble of pre-drying a spool yet
It’s too humid around here for that, especially this time of year. I have to keep mine in a sealed box with desiccant. Putting a new spool in the box without drying it just uses up the desiccant quickly.
At least PETG doesn’t get brittle like PLA when it’s wet. It just gets stringy.