I agree. In fact, that’s what I tend to do - slice up a design by splitting the body/bodies and printing test pieces where tolerances matter. Things like latches, hinges, pieces that have to fit with one another, etc. I’m not sure how practical this approach would have been for this print due to its final orientation, but it’s a really good practice.
I think I got a bit too comfortable with things going per plan over my last batch of designs :( I’ll also admit to being in a bit of a time crunch. No deadline, but I have younger kids so time to model and print is somewhat limited. This is a good reminder that rushing can actually make things take longer in the end.
Massaging this print to fit wasn’t practical. Despite being off by 1% that’s still 2mm of material to remove over some pretty big spans. I did take a chisel to the cutout, but man is ASA tough. PETG is much easier to do that with lol.
Thanks re: print looks great. It’s super solid, so I’m very happy in that regard. I don’t know about you, but lighting greatly impacts how the surface quality of my prints look. Hard/direct light at a steep vertical angle makes the faces look pretty rough, but more diffuse light coming from the side makes the parts look great. I am not sure if this is normal, especially for a larger CoreXY with long 6mm wide a/b belts, or if this is something I can dig into and improve.
I agree. In fact, that’s what I tend to do - slice up a design by splitting the body/bodies and printing test pieces where tolerances matter. Things like latches, hinges, pieces that have to fit with one another, etc. I’m not sure how practical this approach would have been for this print due to its final orientation, but it’s a really good practice.
I think I got a bit too comfortable with things going per plan over my last batch of designs :( I’ll also admit to being in a bit of a time crunch. No deadline, but I have younger kids so time to model and print is somewhat limited. This is a good reminder that rushing can actually make things take longer in the end.
Massaging this print to fit wasn’t practical. Despite being off by 1% that’s still 2mm of material to remove over some pretty big spans. I did take a chisel to the cutout, but man is ASA tough. PETG is much easier to do that with lol.
Thanks re: print looks great. It’s super solid, so I’m very happy in that regard. I don’t know about you, but lighting greatly impacts how the surface quality of my prints look. Hard/direct light at a steep vertical angle makes the faces look pretty rough, but more diffuse light coming from the side makes the parts look great. I am not sure if this is normal, especially for a larger CoreXY with long 6mm wide a/b belts, or if this is something I can dig into and improve.