If that’s true then most of the challenge was “wait until bad weather, pause, move gates up/down. wait until good weather, pause, move gates down/up” which is not much of a challenge. I think that’s fine since they also prevent stupid mistakes where you miss one gate but don’t notice until well after.

Most misleading headline ever, wow

Sounds like Tailwind is facing some headwinds.

I’ll see myself out.

Nice, that’s handy. I use prusa but there are so many options that it’s hard to know what’s available.

What’s a good way to pause during prints? Is there an easy way to stop at a certain y level and move the nozzle out of the way, then resume the print when you are done? Or do you just manually do it?

Oh I didn’t even know they were remaking CE again. Yeah that doesn’t bode well.

What did they change in the CE remake? I don’t remember anything other than graphical changes.

Is 2025 the year of the Linux car?!?! The answer may shock you!