Worst part, this is the one component Prusa injection molded with no parts 3D Printable. I’ll probably figure something out.
You must log in or register to comment.
Send them a message? They are usually very helpful, you might be able to either get a model or a replacement part.
Just print a ne- Oh… Yeah.
Seriously tho: Can’t engineer your own? How complicated is the broken plastic part?
There are some community prints like this. https://www.printables.com/model/194982-prusa-minimini-no-logo-frontrear-plate-with-honeyc
But I don’t know how brave I feel about taking it apart again.
is it Abs? if so you could try welding it with acetone.
Just tried it, worked to hold it in position for a bit. Fell apart once I started to use it mechanically.
Contact them
Superglue?
The plastic is brittle. I think I’ll just delay the inevitable if I use super glue
