I See No Flaws In This Plan
English
Oh, I’m a-doin’ it.
This part is actually slightly outside the “safe print zone” dashed lines on my build plate. I put down like half a can of hairspray on it right before the nozzle descended. Wish me luck.
You must log in or register to comment.
- RunningInRVA@lemmy.worldEnglish4 minutes
Hope you did enough bottom wall layers. The big tray looks like it could be a bit flimsy.
11 minuteshuh, hair spray, makes sense
i’ve been using an FDM-specific spray, but I bet hair spray is more cost effective
- 2 hours
Yeah, I keep all my printers in one place.
Well, except for the laser engraver. I guess you could consider that a “printer.”
- 2 hours
As long as the borders are printing you should be golden. Not something you’d want to to often of course, depending on the printer, since you might strain the hardware at the extreme edges
